Instruction chamfer milling/ Deburring if no chamfer at the model exists.

[SUPPORT]

Instruction chamfer milling/ Deburring if no chamfer at the model exists.
This instruction only refers to a 45 Degree chamfer and a 45 Degree chamfer cutter.

At closed contours
Select contour => 2,5 Axises machining => Profiling
(Please without G41 /G42 or RL and RR)

Tab Mill parameters
- Allowance on profile: “Here you can enter the chamfer width with (- sign).”
- Total depth: “Here is to enter the chamfer width plus a small addition”.
- Step: “Here you can enter 0”.
- Milling cutter radius compensation: Choose between “Conventional- or climb”.
- closed contours: Choose between “External or internal”.

Tab Advanced
- "Sharp corners"

Tab - Entry-/ Exit
- "linear or circular entry"
- "linear or circular exit"

Tab tool
- Mill type: "Conical milling cutter"
- Diameter: "Well-suited for the chamfer"
- Projection length: "Such as milling cutter"
- Edge length: "Such as milling cutter"
- Angle: "45 Degree"

*************************************

At open contours
Choose contour => Control run direction of the contour (polylinie) => 2,5 Axis milling => Profiling
(Please without G41 /G42 or RL and RR)

Tab mill parameters
- Allowance on contour: “Here you can enter the chamfer width with (- sign).”
- Total depth: “Here you can enter the chamfer width plus a small addition”.
- Step: “Here you can enter 0”.
- Milling radius compensation: Select “Left or right to the contour”.
- closed contours. “No selection”.

Tab Advanced
- "sharp corners"

Tab - entry-/exit
- "linear or circular entry"
- "linear or circular exit"

Tab tool
- milling type: "Conical milling cutter"
- Diameter: "Well-suited for the chamfer"
- projection length: "such as milling cutter"
- edge length:"Such as milling cutter"
- angle: 45 Degree